![]() The PC or terminal displays the bootloader sequence. Power on the switch as described in the switch getting started guide. Or ProcommPlus, makes communication between the switch and your PC or terminal possible.Ĭonfigure the baud rate and character format of the PC or terminal to match the console port default characteristics: The program, frequently a PC application such as HyperTerminal Start the terminal-emulation program on the PC or the terminal. Connect the other end of the cable to the switch YouĬan initially configure the entire stack from any member switch.Ĭonnecting the RJ-45 Console Port ProcedureĬonnect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. Switches, connect to the console port of one of the switches in the stack. Ĭonfiguring the Switch Using the CLI Accessing the CLI Through the Console PortĬonfigured or unconfigured switch by connecting the RJ-45 console port or USBĬonsole port of the switch to your PC or workstation and accessing the switch To achieve this, you must complete the following setup tasks as you proceed with theįor more information on the configuration steps involved in completing the Configuration Setup Wizard, see User Guide for Cisco Configuration Professional for Catalyst. Click Go to Wizard.Ĭompleting the Configuration Setup WizardĬompleting the Configuration Setup Wizard enables you to set up your device with the minimum configuration required to enable ![]() The Configuration Setup wizard is displayed. Type the following default credentials: username: cisco, password: cisco and press Enter. Of your Internet browser and press Enter. To log on to the device using an Internet browser on your PC, type the IP address 10.0.0.1 or 10.0.0.3 in the address bar Verify that the port LEDs on the PC and on your device are solid green or blinking green. Continuing to hold the Reset button for longer exits the Setup mode.Ĭonnect a straight-through Category 5 Ethernet cable to a 10/100 /1000 Ethernet port on the switch front panel and to the Ethernet port on the PC. Press and hold the Reset button for 3 to 4 seconds and release it.Ĭaution: Release the Reset button after 3 to 4 seconds. If the STAT LED stillĭoes not turn green, contact your Cisco representative or retailer. Reconnect the AC power cord to the AC power connector of your device and to a grounded AC outlet. ![]() If the STAT LED turns amber, the device failed Initially, the switch acts as a DHCP server.Ĭonfirm that the STAT LED is solid green. Verify that no devices are connected to the switch. Enter the following default credentials: username: cisco,īefore you Begin: If your PC has a static IP address, change your PC settings to temporarily use DHCP. ![]() In your Web browser, enter the IP address 172.16.0.1. Connect your PC to the device usingīluetooth. If your device supports Bluetooth, it loads with the initial setup tasks preconfigured. You can then access the switch through the IP address for further configuration. Switch to connect to local routers and the Internet. When you first set up the switch, use the Configuration Setup wizard to enter the initial IP information. Configuring the Switch Using the Configuration Setup Wizard Quick Setup: Accessing the Configuration Setup Wizard ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |